How do I reset my club car precedent controller?

Easily Reset the Club Car Golf Cart OBC

1. Key switch to off.
2. Set forward/reverse to neutral.
3. Put tow/run switch to tow.
4. Disconnect the negative battery terminal from the battery pack.
5. Put the tow/run switch to run.
6. Put forward/reverse switch to reverse.
7. Put key switch to on.

How do I know if my golf cart controller is bad?

When your golf cart's speed controller isn't operating correctly, your cart will show it by running erratically or failing to drive at one constant speed. If your cart starts showing these symptoms, the first thing you should look at is your speed controller.

How do you test a golf cart controller?

Connect the negative probe to the controller's M terminal and positive probe to the B+ terminal. Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor.

Is there a reset button on a Club Car?

Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.

Where is motor reset button on a Club Car golf cart?

Expose the motor (you'll probably need a screwdriver to remove the cover), and look for a red button. It is usually near the main power source, where most of the wires are connected. Once you've pressed the button to reset the motor, reassemble the cart, charge up the batteries, and give it a test run.

Where are the fuses located on a Club Car Precedent?

Often, this fuse is located behind various panels and near solenoids in your cart. If you don't keep this fuse in good shape, your ignition may end up failing, and you may be unable to start your cart and run into issues with its operation.

Where is the reset button on electric golf cart?

Locate the motor

Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.

How do you bypass a computer on a club car?

To bypass the OBC you will need to connect a 12 gauge black wire from the negative terminal of this battery to where the black wire attaches to the back of the receptacle. That's it folks; you're done!

Is there a fuse in a golf cart charger?

If the Club Car's computer is working correctly, the relay should make a “click” sound when you plug in your charger. If it does not, then you could easily have a blown fuse. If you check the fuse and it is okay, then you could also have a damaged relay, although this is rare.

Why does my electric golf cart not move?

Battery is Dead

That's because battery failure is the most common cause of golf cart operational issues. The battery may be strong enough to “click” the starter but may not be enough to provide power for the rest of your travel. Place your battery on a charger for an appropriate time and remove it.

How do I check my club car precedent in OBC?

How do I know if my OBC is working properly? If the OBC on the Club Car is functional and the batteries are above 35 volts, you should hear a "click" from the relay inside the charger when the round plug is inserted into the cart and the charger should come on and begin charging.

How does a golf cart controller work?

The controller meters out current and voltage on your battery based on user input, whether that be a gas pedal, a throttle, or even pedals on a bicycle. With the controller you are able to control your acceleration and deceleration, as well as the speed at which your vehicle moves.

What happens when golf cart solenoid goes bad?

What Happens To Your Golf Cart When The Solenoid Goes Bad? The large contacts in a gas golf cart may refuse to release, causing the starter to run even after turning off the ignition.

Why Does My Club Car golf cart jerk?

The most common reason for your golf cart jerking is often the battery terminal connections are loose and/or corroded. A poor connection prevents the correct amount of current from flowing through the set of batteries to your speed controller (or resistor coil), and ultimately to your electric motor.

How do I know if my club car OBC is bad?

NOTE: (Note: If you have any (any) corrossion on or around the OBC or any wires leading to the OBC have corrossion or are burnt or darkly discolored due to heat - your OBC is most likely bad. However, your OBC may still be bad if everything appears to looks good visually, so you will need to test.)

Where is the fuse on a battery charger?

The fuse on the battery charger is typically located on the front. Open the fuse cover and remove the old fuse. If you can't get the fuse out with your fingers, use a screwdriver to remove it. Push a replacement fuse into place and close the fuse cover.

Where is the OBC on a club car?

Look for the main negative wire coming off of the last battery in sequence(it will be the only negative wire not going to another battery). If you have an OBC(on board computer) the wire will come off of that negative wire and through the middle of a small box about 4" inches square. The small box is the OBC.

How do you test a power drive 2 charger?

PowerDrive and PowerDrive Plus Vehicles: Monitor the ammeter for about 30 seconds. Under normal operating conditions (when the charger is on and the batteries are discharged), the ammeter will drop to zero for 2 to 3 seconds at the beginning of each charge cycle in order to perform a self-diagnostic test.

How can I make my 48 volt Club Car Precedent faster?

6 Ways You Can Make a Golf Cart Faster

1. Add More Torque to Your Golf Cart.
2. Upgrade Your Golf Cart's Motor.
3. Improve the High-Speed Controller of the Cart.
4. Add Better Golf Cart Tires.
5. Use a Higher Powered Golf Cart Battery.
6. Watch the Weight in Your Golf Cart.

How do you remove the speed limiter on a electric golf cart?

Basically, an electric speed governor can be controlled by a tiny metal rod that's located by the clutch of your golf cart. First things first: The electric speed governor is connected to a cable. You can adjust your speed by rotating the nut in a counterclockwise rotation.

How do you bypass the solenoid on a Club Car golf cart?

Bypassing Golf Cart Solenoid Method

If you do decide to bypass the solenoid, this is what you need to do: Take the two larger wires that connect to the solenoid and connect them directly (keeping all safety precautions in place). This should do the trick and if it does not work then the solenoid is not the problem.

How do I reset my Club Car golf cart?

Easily Reset the Club Car Golf Cart OBC

1. Key switch to off.
2. Set forward/reverse to neutral.
3. Put tow/run switch to tow.
4. Disconnect the negative battery terminal from the battery pack.
5. Put the tow/run switch to run.
6. Put forward/reverse switch to reverse.
7. Put key switch to on.

How do you troubleshoot an electric golf cart?

There are a few simple problems that you can fix yourself that will not necessitate professional maintenance.

1. Test the wall socket where you charge your cart. ...
2. Expose your golf cart batteries. ...
3. Test the batteries for voltage. ...
4. Replace dead batteries. ...
5. Expose the motor for inspection. ...
6. Reset the motor. ...
7. Test the cart.

Where is the fuse box on an electric golf cart?

Where are the Fuses on a Golf Cart Located? You can use your golf cart's service panel to help you find where the different fuses are located. The service panel is commonly located on the rear fender, although this will vary from model to model. Trace the malfunctioning issue to the appropriate fuse.